- Messages
- 2
Hi I have a LHD ep3 SiR and was planning on installing the frame bracing from the JDM CTR.
The rear strut tower brace and front lower frame brace seem pretty straight forward but I am confused about this upper brace (part no. 74180-S5T-300ZZ):
The euro type r has one too but it is split into 2 pieces (part no. 74180-S5T-G00ZZ & 74185-S5T-G00ZZ):
I would assume that this mounts under the scuttle panel but it does not exist on the USDM/Canadian cars and I have found little info on it.
Does anyone know where this bar is mounted and if either the JDM or euro version fits on the non-type r
The rear strut tower brace and front lower frame brace seem pretty straight forward but I am confused about this upper brace (part no. 74180-S5T-300ZZ):
The euro type r has one too but it is split into 2 pieces (part no. 74180-S5T-G00ZZ & 74185-S5T-G00ZZ):
I would assume that this mounts under the scuttle panel but it does not exist on the USDM/Canadian cars and I have found little info on it.
Does anyone know where this bar is mounted and if either the JDM or euro version fits on the non-type r