- Messages
- 1,348
This is for the benifit for the people who have bought an earthing kit but cannot open the MS office word file.
Grounding Kit Fitting Instructions
Tools Required
10mm spanner
10mm socket and ratchet
Side cutters / snips
Tips
-Do not cable tie up anything until you have bolted up ALL the connections. This will make the installation quicker and neater
-Make sure you leave nothing loose. i.e. the bolt on the negative terminal and I-Vtec cover.
-Make sure the plastic cover is on the positive terminal as you really don’t want to short it out with the ends of the earthing kit.
STEP 0
Undo the nut on the NEGITIVE terminal on the battery and bolt on the ends marked 0. The loom with the number 1 on is best facing the front of the car as seen in the picture below.
STEP 1
Connect 1 to the battery tie bar as shown in the picture above.
STEP 2
Route the rest of the loom around the back of the engine bay and connect 2 to the bulkhead as shown in the pictures below.
STEP 3
Connect 3 in to the top right of the Red rocker cover as shown in the pictures below.
STEP 4&5
Now with the other ½ of the loom, connect 4 into the manifold and 5 into the throttle body as shown in the picture below.
Grounding Kit Fitting Instructions
Tools Required
10mm spanner
10mm socket and ratchet
Side cutters / snips
Tips
-Do not cable tie up anything until you have bolted up ALL the connections. This will make the installation quicker and neater
-Make sure you leave nothing loose. i.e. the bolt on the negative terminal and I-Vtec cover.
-Make sure the plastic cover is on the positive terminal as you really don’t want to short it out with the ends of the earthing kit.
STEP 0
Undo the nut on the NEGITIVE terminal on the battery and bolt on the ends marked 0. The loom with the number 1 on is best facing the front of the car as seen in the picture below.
STEP 1
Connect 1 to the battery tie bar as shown in the picture above.
STEP 2
Route the rest of the loom around the back of the engine bay and connect 2 to the bulkhead as shown in the pictures below.
STEP 3
Connect 3 in to the top right of the Red rocker cover as shown in the pictures below.
STEP 4&5
Now with the other ½ of the loom, connect 4 into the manifold and 5 into the throttle body as shown in the picture below.