• Registered users are encouraged to enable MFA/2FA to add an aditional layer of security to their account. More information can be found here: https://www.ncsc.gov.uk/collection/top-tips-for-staying-secure-online/activate-2-step-verification-on-your-email

Recent content by jizzy

  1. jizzy

    Rattle noise guidance please

    If the chain stretches it can bring on the eml with incorrect phase between cam & crankshaft sensor and can possably not start As for cost , have a search for an independent Honda specialist they will be cheeper than the dealers Price around £450 job done from an independent
  2. jizzy

    What did you do to your Type R today?

    Hks suction reload kit , fn2 , sounds the dogs do dars
  3. jizzy

    Rattle noise guidance please

    Does sound like the timing chain tensioner,Tegiwa do good deals on genuine honda ones, have alook in the traders section, obviously you will have to replace the chain as well & get the tappets set at the same time
  4. jizzy

    EP3 Engine problem

    Defo the timing chain streched/jumped, incorrect phase is the most acurate & common fault code
  5. jizzy

    EP3 EP3 hamilton and palmer alarm trouble.

    We used to fit them & the box was under the drivers seat, 2 cuts to the ignition & 2 cuts to the fuel pump, Fuel pump wires located behind glovebox & central locking wires located o/s/f kick pannel
  6. jizzy

    Window rubber runner

    I do loads of them at work so im use to doing them in situe but you might have to remove door card & glass if you get stuck but there quite easy
  7. jizzy

    EVO 6 Alloys on FN2 need Help!

    Just let me how much you want for them & we can go from there As i said thow the rims on the 1st pic look awsome
  8. jizzy

    EVO 6 Alloys on FN2 need Help!

    1st pic does it for me :smt023 If you sell your Rage alloys then send me a pm with how much
  9. jizzy

    Window rubber runner

    Sorry for mate reply mate Yes you can use washin up liquid but idealy wd40 or similar
  10. jizzy

    Window rubber runner

    The run channel seal is the pic above , yes thats the part you need To replace it put window down then just pull top left corner down & out of the seal, then peel it out of the run channel then pull the seal up etc Then to fit new 1 lube up the back of the seal & slide the seal down the window...
  11. jizzy

    Loose pipe

    Looks like the AC Drain:smt023
  12. jizzy

    Flexi pipe induction ?

    I wouldnt route it from the foglight blank/fog lamp as if u go through a puddle then the possability of majour engine damage will happen
  13. jizzy

    2009 FN2 type R - battery issues - completely dead if left stood for a day

    Has it got HFT fitted as we have loads of issues with these causing a current drain
  14. jizzy

    Strange cables

    Looks like srs bypass wires with a 2ohm resistor/diode mayb get the srs system code read
  15. jizzy

    Paint Care

    Use G3 it will go in seconds with a bit of elbow grease lol then just buff back up with car polish it will be fine
Back
Top