Search results

Hi everyone I bought the tegiwa induction kit for my ep3 from tegiwa and the scoop to go on scuttle panel came with a little box of 6 bolts and 6 of these silver things with tegiwa written on them. How the hell do I secure it under the scuttle panel so it don’t blow away the moment I drive...

Hello everyone I hope you are all well. My ep3 currently has. Kn typhoon induction kit Spoon n1 backbox Silenced 2.5 b pipe *ebay part* I had hoped my car fell in the 205hp to 210hp range with these mods. I went to a dyno yesterday in boreham my car after few pulls produced 193.6hp...

I want to get some new headlight bulbs ideally white and nice and bright that are a direct replacement for standard bulbs I believe h4 fitment is what I need. Any suggestions please.

Hi everyone. Really worried at the moment my car for a while has made this sound when the key is turned to on position the one before the car would start. I changed the battery made no difference. I checked fuses all seem ok The noise doesn't always happen when it does if you knock the car...

Skunk 2 gearknob Kn typhoon Spoon n1 backbox Silenced b pipe 2.5 Single din stereo

Hello everyone. I bought a used spoon n1 in pretty good condition and a new 2.5 silenced b pipe off eBay it’s all installed last 3 weeks. The car sounds good I like it no drone at 60 or 70 seems perfect just a little too quiet. When I boot the car top end I hear induction noise over it...

Hi everyone. On the 16th of March my car went in for painting to have rear bumper painted and key damage and my wheels were being sent off to a refurb place to be painted. My car has been on axle stands in the middle of the paintshop since the 16th of March and the place that has my wheels...

Hi people I currently run an 02 ep3 with unsilenced b pipe and standard backbox. I have bought a 2nd hand spoon n1 off eBay in very very good condition 225 inc delivery I’m a tad nervous that this may have been a mistake due to the b pipe unsilenced and extreme noise levels that may come...

Hello people I have bought a single din stereo and the facia to replace my standard stereo and CD changer. I want to know if replacing the stereo will it affect the alarm because I know you have to enter a code and there is a blinking red light on stereo. Will it all be fine I see many...

Hi people little while back I disconnected my battery on my 2002 type r ep3 anyways reconnecting the battery car starts fine but when I got out of the car and locked it using the fob the car made 2 chirps.reminds of the sound vin diesel rx7 made in fast and the furious 1 when he parks it in the...

Hi everyone I want to share my problem and fix Thanks to the help of a fellow youtuber My 2002 ep3 had a issue when warm I would rev the car and it would drop to 500rpm then raise to 900rpm and I have had this issue near on a year and really depressed me.trying to reset ecu and idle...

I want induction kit for increased performance and sound but I want car to look original. Is it possible to fit a cone filter directly to pipe that goes to standard air box I want to keep the air box to prevent heat soak and cone filter trapped inside.

Problem I have is setting the handbrake as passenger side drags before cable setup so drivers side set up perfect means passenger side fully locked. Watch video please I made it in 2 parts I have got a new passenger side cable on the way. https://youtu.be/z9wJloc7RGw https://youtu.be/TRjcdekV7HY

Hi people my ep3 idles about 1500rpm cold and about 900rpm when warm but I noticed that when you rev the car it drops to around 500rpm then Goes up to roughly 900rpm then settles. I don’t like the fact it does this any ideas on a cure. Step by step instructions would be nice if possible...

Hi people I have an issue with my ep3, I get an annoying noise from rear brakes when driving as me and mechanic found today an issue with the handbrake cable when letting off it still binds a little we could see this behind the rear calliper on passenger side.he recommended new cables for both...

I want to get an aftermarket backbox possibly an m2 to fit the standard system.curious if it will cause an eml light and drone. Anyone fitted a backbox and any suggestions on brands etc.input from experience is appreciated. Thanks

Hello peeps. I have an 02 ep3 with air con.i would like to know if it is possible to bypass the ac pulley with a shorter belt like the one from a non ac model. Something tells me that it is not that simple. Input from experience would be appreciated.