Home

Search:

Type: Posts; User: CR54WDS

Page 1 of 16 1 2 3 4

Search: Search took 0.04 seconds; generated 2 minute(s) ago.

  1. Replies
    1
    Views
    119

    They'll fit, but you'll need S2000 disc's and...

    They'll fit, but you'll need S2000 disc's and decent new pads....
  2. Thread: ep3 clutch

    by CR54WDS
    Replies
    12
    Views
    368

    One owner car?

    One owner car?
  3. Thread: ep3 clutch

    by CR54WDS
    Replies
    12
    Views
    368

    Once you've checked the clutch reservoir and or...

    Once you've checked the clutch reservoir and or bleed the clutch, if its still stuck (won't disengage) put it in 4th gear, sit in the car with the clutch depressed and get some mates to push the car...
  4. Replies
    2
    Views
    155

    Hi, I'd source good second hand replacements and...

    Hi, I'd source good second hand replacements and get them flow tested....
  5. Thread: P0138 code

    by CR54WDS
    Replies
    6
    Views
    340

    Hi, bought one from Euro's 4 years ago, still...

    Hi, bought one from Euro's 4 years ago, still going strong....


    PS...The P0138 code is set when the Engine Control Module (ECM) detects that the rear O2 sensor signal voltage remains excessively...
  6. Thread: Buying an ep3

    by CR54WDS
    Replies
    14
    Views
    814

    I'd steer clear, it could turn into a money pit -...

    I'd steer clear, it could turn into a money pit - there are nice ones around with little or no rust....
  7. Replies
    5
    Views
    634

    The additional kerbs added at Bobbies & the Esses...

    The additional kerbs added at Bobbies & the Esses are fine, you've still got painted kerb to use, the additions are sausages at 90 degrees pointing in...
  8. Replies
    5
    Views
    634

    Chris, it's open pit lane, track time is 09:00...

    Chris, it's open pit lane, track time is 09:00 till 17:00 and not anticipating a lunch break?

    Open track is running it.
  9. Replies
    5
    Views
    634

    Castle Combe, Monday 8th June 2020

    Anyone booked on this trackday?
  10. Check the connector on the lambda loom, it may...

    Check the connector on the lambda loom, it may have come apart a little?

    Otherwise it maybe you've touched/disturbed sensor and it's now gone faulty, you could remove it and test it, if you know...
  11. Throttle position sensor - intermittent fault ?...

    Throttle position sensor - intermittent fault ?

    Have you ever changed it, as the copper tracks do deteriorate...
  12. Replies
    6
    Views
    579

    Umm Yes, oops :smt053

    Umm Yes, oops :smt053
  13. Replies
    6
    Views
    579

    Firstly, semi slick & good in the wet don't go...

    Firstly, semi slick & good in the wet don't go together. I would recommend AD08R's, but you cannot buy them any more. They are a good daily as well as a track tyre, the replacement is generally...
  14. Replies
    2
    Views
    244

    The wheel studs are a "push" fit in to the hub,...

    The wheel studs are a "push" fit in to the hub, the above method will not work. The old stud needs to be knocked out, remove the disc & caliper first, using a large hammer knock it out , using an...
  15. Thread: Rust removal

    by CR54WDS
    Replies
    6
    Views
    572

    I used bilt hamber dynax cavity spray, Hammerite...

    I used bilt hamber dynax cavity spray, Hammerite Underbody seal & Rustins Rust Converter...

    https://www.bilthamber.com/dynax-s50
    ...
  16. Replies
    29
    Views
    3,741

    Bit of a long shot - sub frame bolts?

    Bit of a long shot - sub frame bolts?
  17. Hi, If you had the bore enlarged by 0.25mm by my...

    Hi, If you had the bore enlarged by 0.25mm by my calculations , the cubic capacity has gone from 1997 cc to 2010 cc, (although my maths is rusty)so no you wont notice any difference due to the...
  18. I used Eibach springs with Bilstein B8's but not...

    I used Eibach springs with Bilstein B8's but not coil-overs
  19. Replies
    8
    Views
    773

    The lowered suspension can cause the...

    The lowered suspension can cause the whitelining/tramlining and not centering type steering, I fitted a rack raiser and its now sorted... (It raises the angle of the track rods to nearly level...)
  20. Replies
    5
    Views
    483

    Yes, it can be used to operate a relay, make sure...

    Yes, it can be used to operate a relay, make sure the relay live feed to the airhorns compressor has an inline fuse from the battery, if you're coming straight off the live terminal on the...
  21. Replies
    3
    Views
    895

    Norv, how many aerosol's did you use on your car?...

    Norv, how many aerosol's did you use on your car?

    I was thinking two?
  22. Replies
    3
    Views
    895

    Waxoyl cavity advice

    Hi, I going to Waxoyl inside the chassis of my EP3, what did you use, Waxoyl or Testroseal or another?

    I don't have a compressor in my garage, so I have to use a hand pump type (as shown below...
  23. Thread: E10 petrol

    by CR54WDS
    Replies
    7
    Views
    1,850

    Is my car compatible with e10 fuel? As a...

    Is my car compatible with e10 fuel?

    As a general rule, most cars post-1986 can run on E10, whereas most cars that once ran on leaded fuel or are carburetted cannot. ... Many European vehicles,...
  24. Replies
    4
    Views
    457

    Recommendation please Clay Bars

    Well, I seem to have a lot of time on my hands at the moment, so I thought I'd clay bar the R, so any recommendation, but its got to be available online...

    Thanks :D
  25. Replies
    0
    Views
    229

    Made me smile...

    https://hosting.photobucket.com/images/h69/crowds54/0/leg%20end.jpg

    Stolen from another site!
Results 1 to 25 of 385
Page 1 of 16 1 2 3 4