- Messages
- 983
Is there any issues with mating a 2in inlet backbox to a 2.4in b pipe.
or is best to keep bore size consistent all the way through ie 2.4 and 2.4
Trouble is - there is not many 2.4 inch backbox around, all 2.5inch backbox. I heard if you go bigger - you loose back pressure and therefore lose low down torque.
Can someone advise?
or is best to keep bore size consistent all the way through ie 2.4 and 2.4
Trouble is - there is not many 2.4 inch backbox around, all 2.5inch backbox. I heard if you go bigger - you loose back pressure and therefore lose low down torque.
Can someone advise?