Superpro Caster degree?

[bowman]

Ive just picked my car up from having my springs & bush kit fitted & FRSU etc.
Ive noticed on my alignment printout that the front left 2.24deg and right is 1.56deg

What should the caster be roughly?

Also noticed that speeds 70+ it pulls to left slightly... so I presumed that was down to the caster difference?




Also my FRSU setup came back as follows:

Camber:
LF -0.55, RF -0.52
LR -0.58, RR -0.52

Toe:
LF 0.13, RF 0.12 - TOTAL 0.25
RR 0.06, LR 0.06 - TOTAL -0.12

 

[Stoo.]

Camber and toe values are good so they won't be causing your pulling issue.

Nice and straight, and your geometric drive axis will be roughly 0.

However, looking at your caster values, it should pull to the right....

It's roughly half a degree different, and it'll pull to the side with most positive caster.

 

[Stoo.]

Althogh, you're 'FRSU' measurementS aren't very aggressive.

 

[bowman]

Yeh I did ask for 1 deg camber tbh! but he had to take it to another company for the alignment, so didnt have chance to get it changed. And this is the setting he found on the internet apparently. But im popping back up shortly to get the caster fixed, so will get abit more camber put on

is the toe ok or need to be more aggressive also?