• Registered users are encouraged to enable MFA/2FA to add an aditional layer of security to their account. More information can be found here: https://www.ncsc.gov.uk/collection/top-tips-for-staying-secure-online/activate-2-step-verification-on-your-email

Recent content by Mr west

  1. Mr west

    rotrex fitting

    Tts performance mapped it. They also put a base map on my ecu so i could drive it there to be set up properly. Need to intercool it really
  2. Mr west

    rotrex fitting

    Dynoed today... made 330 bhp @ 7700rpm. Intake temp was too high to rev out further otherwise would be a touch more. Quite happy
  3. Mr west

    Wondering if someone can help ??

    I run yellow stuff pads and ultimax discs on toyo t1r rubber. Cooked standard brakes and found Bridgestone protenza too hard and lacking feed back
  4. Mr west

    rotrex fitting

    The joys of modified cars. In case you're wondering where to pick up the vacuum for dump valve from. There is a vac hose on the left of inlet manifold just above the alternator. T into that
  5. Mr west

    rotrex fitting

    Yeah its all shoehorned in. I had to get a flexi hose to replace bottom rad hose. Not keen on the filter sitting on end of charger behind rad either.
  6. Mr west

    rotrex fitting

    So have you got slimline rad too?
  7. Mr west

    rotrex fitting

    Mine is non intercooled by the way. Before you drill a hole you don't need
  8. Mr west

    rotrex fitting

    Hi mate yeah i have. All done now. Drill a hole in the pipe before fitting and place a grommet in it for the IAT sensor. Any help you want just ask. Its all a bit fiddly but straight forward
  9. Mr west

    Pads and disc set up 70/30 road track day

    Maybe im not braking hard enough then lol. Cooked the standard pads but not these yet but haven't been on track yet neither
  10. Mr west

    rotrex fitting

    More questions. .. where do people normally pick up the vacuum for the dump valve?
  11. Mr west

    Pads and disc set up 70/30 road track day

    Was that recently? Old yellow stuff was ***** but made a new compound. Is on all pursuit cars.
  12. Mr west

    temp gauge not reading

    Yeah had it running, blead it up.might have to remove bumper again to see if i pulled the plug in the block.
  13. Mr west

    temp gauge not reading

    Morning all i have had the rad off to go some work. All back on with both fan switch and temp sensor plugged into rad. But my gauge is not even moving. As if ignition is off. Checked . fuseshelp please. ..??
  14. Mr west

    Pads and disc set up 70/30 road track day

    I run ebc ultimax slotted disc's with yellow stuff pads. Not cooked them yet and have great bite from cold
  15. Mr west

    Ep3 Brakes

    Even if its a new caliper they are only about 60 quid (not from honda)
See more
Back
Top