Search results

Hi, I am trying to get the hydraulic chain tensioner off of my 02 CTR but I can't remember how to release the tension off before I un-bolt it! does anyone know how to do it please? there's the small lever on the top with the spring behind it then there's a hole in the side where there was a pin...

Morning people, I have had the timing chain, guides and hydraulic tensioner replaced on my 02 ep3, the chain stretched and it jumped a couple of teeth! The car sat for a couple of weeks while this was being done, long story short I was trying to source a cheaper alternative to having all...

Evening people, My engine management light has been on for a week or so ive had it on the scanner and it came up with camshaft sensor A (inlet bank) i hadnt got it replaced by this point as was freeing up some money to get one. I got in my car Thursday evening turned the key and it wouldn't...

Evening people, I parked my car up at work the last week, when i got in to go home the engine management light came on and stayed on! I got my bro to plug the scanner into it and its coming up with a camshaft sensor fault, im told by honda (after phoning them for a price) that there are three...

Evening, I recently bought a pair of smd led capless side light bulbs for my 2002 NHB EP3, I've been really impressed with the brightness of them and they look good to, so I've been looking at possibly getting the same for the headlight bulbs, I've seen them on eBay but a lot of them say not...

Hi all, I need to replace my rear tyres on my CTR ep3 and was thinking of going for a lower profile this time round, 205 40 17 instead of 45's, replacing both rears for now then doing the fronts later as they still have some life in them yet. Has anyone done this as well and if so did you...

Morning, I was tying to locate some stainless steel kick plates for my 02 ep3 but not having much luck! Anyone know where I could get hold of some? Possibly without spending a small fortune!! Cheers