- Messages
- 15
Hello everyone.
I just purchased a EP3 from 2005 with only 48.000 miles on it(77.000 km) and it is completely stock and converting into a ring tool.
So I have ordered and will put on this weekend the following:
KYB Shocks
Eibach Pro lowering springs
Camber bolts
Hardrace Camber arms
JDM Rear antiroll bar
(Of course also all new brakes, pads, lines, brake fluid, Advan Tires ect ect)
So what is the recommended setup for the suspension?
From what I have found while searching is:
-1 deg camber on each wheel
2mm toe in rear
1mm toe out front.
Is this the setup to get or could you run a bit more negative camber as the car will mainly be used for the ring?
(Looking for a stable fun setup)
Pleased to hear.
I just purchased a EP3 from 2005 with only 48.000 miles on it(77.000 km) and it is completely stock and converting into a ring tool.
So I have ordered and will put on this weekend the following:
KYB Shocks
Eibach Pro lowering springs
Camber bolts
Hardrace Camber arms
JDM Rear antiroll bar
(Of course also all new brakes, pads, lines, brake fluid, Advan Tires ect ect)
So what is the recommended setup for the suspension?
From what I have found while searching is:
-1 deg camber on each wheel
2mm toe in rear
1mm toe out front.
Is this the setup to get or could you run a bit more negative camber as the car will mainly be used for the ring?
(Looking for a stable fun setup)
Pleased to hear.
Attachments
Last edited by a moderator: