Suspension Setup

[ukjosh123]

Hi guys, I have a type r ep3 and i have a set of 30mm eibach springs to go on. I was wondering if i could use them on the factory alignment settings for a few months until i get my camber adjusters or wait till i have the camber kit ?

I will be getting the rear ARB and rear control arms when i buy the camber kit and get it all done at the same time.


Also when i get my camber kit are these settings fine for just a road set up


1 deg negative camber all round.
0.5mm toe in at the back
0.5mm toe out at the front

 

[Chris.]

I'd wait and get it done at the same time. The EP3 has MacPherson struts so lowering the car will affect the geometry.

 

[ukjosh123]

ok cheers. I will wait and get it all set up properly.

 

[Collister]

you would tend to run more toe on the back than the front unless racing and you want lift off oversteer. As it has a greater effect on the front.