Lottie
The Duchess
- Messages
- 4,504
Tools/Equipment
19mm Socket
19mm Spanner
Front
TRS Tow Strap
Harness Stress plate with thread removed
M12 Bolt 35mm length
M12 Nylock Nut
Dremel or Stanley Knife
1. Place the stress plate with welded nut facing downwards on the OEM towing point
2. Place the Nylock Nut on top of the plate, the TRS strap under the OEM towing point and hold in place with the M12 Bolt.
3. Tighten
4. Use a Dremel or Stanley knife to cut a small slit in the bumper rubber strip
.
5. Pull the strap through to keep it from flapping when driving (if needed it can easily be pulled out).
Rear
TRS Tow Strap
Galvanised Steel 40mm x 40mm plate (4mm thick and central 13mm diameter hole)
M12 Bolt 35mm length
M12 Nylock Nut
Cable Tie
1. Place the plate on one side of the OEM towing point and the TRS Strap on the other.
2. Place the M12 Bolt through the plate, OEM Towing point, TRS Tow Strap and put the M12 Nut on.
3. Tighten.
4. Fold the TRS Strap in half and keep together with a cable tie.
19mm Socket
19mm Spanner
Front
TRS Tow Strap
Harness Stress plate with thread removed
M12 Bolt 35mm length
M12 Nylock Nut
Dremel or Stanley Knife
1. Place the stress plate with welded nut facing downwards on the OEM towing point
2. Place the Nylock Nut on top of the plate, the TRS strap under the OEM towing point and hold in place with the M12 Bolt.
3. Tighten
4. Use a Dremel or Stanley knife to cut a small slit in the bumper rubber strip
.
5. Pull the strap through to keep it from flapping when driving (if needed it can easily be pulled out).
Rear
TRS Tow Strap
Galvanised Steel 40mm x 40mm plate (4mm thick and central 13mm diameter hole)
M12 Bolt 35mm length
M12 Nylock Nut
Cable Tie
1. Place the plate on one side of the OEM towing point and the TRS Strap on the other.
2. Place the M12 Bolt through the plate, OEM Towing point, TRS Tow Strap and put the M12 Nut on.
3. Tighten.
4. Fold the TRS Strap in half and keep together with a cable tie.