Search results

Well as i have had it for 2 months now and haven't put it in here yet i thought i would give it a bit of detailing and post it up. Started yesterday morning about 8am and finished this morning about 10am.....obviously with a break in between for some sleep.:D Alloys cleaned...

Well having taken the FN2 out recently i am smitten but in the back of my mind i have a nagging doubt and i don't know why. I am in the position to buy a new motor in the next few weeks and i can't decide between the FN2 and the EP3. I loved my EP3 when i had it and to be honest i never...

Anyone know the weight of one of these by any chance please.

Hasn't been working for a couple of weeks. Plenty of water in the bottle. If i lift the cover off the rear wiper and squirt it the water shoots up ok but when i put the cover back down the water just splatters all down the boot. Am i missing something here.......how does the water get...

The beast is due for her second service this month. Been quoted £300 by Southern Counties Honda in Crawley. Is this about right or does it seem a bit steep to you. There will be a little off this as i don't want them to change the air filter.

http://www.carbibles.com/tyre_bible.html

Honda 2005 Colour codes Thanks to Davey S for providing this 8) Code Colour name B92P Nighthawk Black Pearl B96P Eternal Blue Pearl B502P Indigo Blue Pearl B507P Arctic Blue Pearl B510P Long Beach Blue Pearl B512M Magnetic Blue Metallic B513M Nuerburgring Blue Metallic...

What do you think? I know you would all like to see Champ White but do you think the CTR should have all the choices available to other cars or at least a few more. Perhaps the smallish (compared to other marques )production run doesn't allow this...........i don't know. The Blue...

Here's how to fit these little babies onto your pride and joy, hope it all works out ok Here's the tools you will need, 19mm wheelbrace, 8+10mm sockets, ratchet, extensions, a phillips and flat screwdrivers. You might need one of these if you're like me and have a bad back :wink...

The main problem that trips people up is the wiring plug is different from the doors loom plug on the later mirrors. So what I do is cut the plug off the new mirror and fit small spade terminals to the corresponding cables individually, then, after a small piece of heatshrink tubing is fitted to...

This is just a few pics of how to go about making a new cowl to fit around the opening to the filter. The one that comes with the kit looks out of place (having a gloss finish) and was nearly putting me off going above 4500 rpm :( because of the bloody rattle. using the new gruppe m cowl...

It's pretty easy to fit, you'll need one stubby crosshead screwdriver and a hairdryer. The wide bits of tape go on the lower side of the grille where it sits on the bumper. I've no idea what the long thin one's for, I binned it. Open the bonnet and take out the 8 clips holding the top of the...

The below steps are intended to help you through the installation of the genuine Honda fog lights P/N: 08V31-S5S-611. You will be supplied with definative instructions with the part, therefore the instructions and pictures below are there to supplement those supplied with the part. Step 1...

Moving steering wheel to top position (how i have it anyway). Undo the 3 screws underneath. (remember the short one goes nearest the bottom.) Gently separate the bottom from the top piece. (held together with tabs). Then i dropped the handle to adjust the coloumn and slid the lower...

http://www.miata.net/garage/tirecalc.html

Here comes a description of how to remove the door cards of our cars ! Read and follow step by step then everything will work without damaging the door card, A: Behind the "handle" here you will find a small hole in which you put a small screwdriver or something else and push inwards, this...

http://gallery.themspros.com/view_album.php?set_albumName=removerearbumper with thanks to KrystenCTR.......the big bugger :wink: