RickHondaR
R-32840
- Messages
- 1,903
1, clip out the airbag logo I used the point of a sharp knife and did this from the top edge
2, get an 8mm socket and remove the bolt
3, open the door and remove the door seal around this area
4, pull the trip forward from the top corner. This clips around the dash at low level so I did not remove this there but pull forward to give the access required
5, get some foam tape like this https://www.ebay.co.uk/itm/Single-S...hash=item3a8467ebcb:m:mr9wILNeAeFePWhx9swmGfg
6, apply some foam tape to the plastic positioning teeth that meet the metal trim next to the window screen and the 2 x metal plates where the bolt goes and the panel retaining clip.
7, refit
feel free to do a how to guide with photo when you do yours
2, get an 8mm socket and remove the bolt
3, open the door and remove the door seal around this area
4, pull the trip forward from the top corner. This clips around the dash at low level so I did not remove this there but pull forward to give the access required
5, get some foam tape like this https://www.ebay.co.uk/itm/Single-S...hash=item3a8467ebcb:m:mr9wILNeAeFePWhx9swmGfg
6, apply some foam tape to the plastic positioning teeth that meet the metal trim next to the window screen and the 2 x metal plates where the bolt goes and the panel retaining clip.
7, refit
feel free to do a how to guide with photo when you do yours
Last edited by a moderator: