- Messages
- 426
I was supposed to be doing my sparks today but I got carried away doing the Hondata Airbox Mod on my Prem.
I would not do this again without a Dremel [mine broke a while ago].
So I used a Hacksaw, Jr Hacksaw, Coping Saw, File, and Side Snips. It took over an hour of sawing and swearing!
Its all done now, but I havent popped it back into the CTR yet because I am going out for the day
I am going to do the sparks tomorrow and pop the Box back in. I will report on results.
Following this little mod I am doing to get a 90mm+ heatproof CAF to improve flow.
Before:
After:
CAF
I would not do this again without a Dremel [mine broke a while ago].
So I used a Hacksaw, Jr Hacksaw, Coping Saw, File, and Side Snips. It took over an hour of sawing and swearing!
Its all done now, but I havent popped it back into the CTR yet because I am going out for the day
I am going to do the sparks tomorrow and pop the Box back in. I will report on results.
Following this little mod I am doing to get a 90mm+ heatproof CAF to improve flow.
Before:
After:
CAF
Last edited by a moderator: